All you need is a tshirt.
Step 1: Cut two 1 to 2 inch strips from a tshirt and pull to strecth them.
Step 2: Take one strip, and fold it like you see in the second photo.
Step 3: Take the other strip and lay it on top like shown in the third photo.
Step 4: Take the right "leg" of the first strip, and lay it on top of the second strip.
Step 5: Take the "loop" of the first strip and lift it up. Now take the left side of the "U" and lay it underneath the loop like in the fifth photo.
Step 6: [it gets a little tricky here] Take the piece of the left side of the "U" that is inside the loop, a lift it up. Now take the right side of the "U" and make it cross through the loop by going over the loop then under the piece in the middle [that you lifted up] and then over the other side of the loop. [see photo 7 for a close up of this step]
Step 7: Pull slowly, trying to keep the form of the knot. Tie the bracelet around your wrist and cut of excess. You're done!!
If you don't cut off the excess, this could even be a headband!
total cost: free
<3
No comments:
Post a Comment